Jaypro sports – Jaypro Sports PB40PC User Manual
Page 2

JAYPRO SPORTS
4’ PLAYER’S BENCH WITH BACK REST, PB-40PC
LIST OF MATERIALS
PIECE NO. PART
NO. DESCRIPTION
QTY.
1
AR5044
Bolt Clip With Slot
8
2
AR5045
End Cap
4
3
HB5030
Carriage Bolt 5/16”-18 X 3”
8
4
HN5046
5/16” Flange Nut
8
5
HS5035
#8 Pan Head Screw x ½”
8
6
EP0018
2” End Cap
8
7
AR5087
4 Ft Seat Plank
2
8
PB801
Leg
2
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Phillips Screwdriver Bit With Electric Drill (1),
½” Socket Wrench Or Adjustable Wrench (1)
1) Slip the end caps (2) snugly onto each end of the plank (7). Using the electric
drill, assemble a self-drilling screw (5) through the cap and into the flange of
the plank. Two screws are required per end cap. Carefully assemble 2” end
caps (6) into bench legs (8).
2) For easiest assembly, position seat plank (7) on a level raised surface such
as a desk top, bleacher seat or work bench. Place the carriage bolt (3) and
bolt clips (1) approximately into place within the slots of the plank. Note that
the legs should be no more than 8” from the plank edge.
3) ,Position the legs as shown and loosely assemble the hardware illustrated in
detail ‘A-A’. Do not fully tighten the hardware at this time.
4) Stand the unit upright and assemble the backrest plank (7) as illustrated.
Level the bench and make sure the legs are adequately spaced apart.
Tighten all fasteners fully.