beautypg.com

Jaypro sports – Jaypro Sports SGP-550 User Manual

Page 2

background image

REV-A

2/8/2011

JAYPRO SPORTS

SEMI-PERMANENT / PERMANENT WORLD COMPETITION GOAL, SGP-550


ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED: BOX WRENCHES OR MED. ADJUSTABLE WRENCH

PHILLIPS HEAD SCREW DRIVER

7/32” ALLEN WENCH

PLIERS

STEP LADDER


1) Lay-out footing locations as shown and dig footings to the minimum dimensions

indicated. This may require the services of a qualified contractor familiar with
local building codes. To assure a proper alignment of the goal facing within the
footing, it is necessary to assemble the uprights (2 & 3) to the crossbar (1) before
cementing the structure into place. Lay the crossbar (1) onto the ground and
position the uprights. Push the uprights firmly into each end of the crossbar (1)
and make sure each insert is fully seated, then assemble with machine screw (7)
and washers (5 & 6) as shown in the illustration.

2) Semi-permanent installation:

Slip the ground sleeves onto the bottom of each upright and lower the assembled
goal facing into the footings. Block beneath and around the sleeves, plumb the
structure and pour the footing. Check that the ground sleeves do not stick above
the playing surface and that there is 8’ from the playing surface to the underside
of the crossbar. Brace the structure to assure that it doesn’t shift during the curing
process. Follow the same general procedure for back post sleeves. Allow
footings to fully cure before final assembly and use of the goal.

3) Permanent installation :

Lower the assembled goal facing into the footings. Block beneath and around the
sleeves, plumb the structure and pour the footing. Check that the ground sleeves
do not stick above the playing surface and that there is 8’ from the playing surface
to the underside of the crossbar. Brace the structure to assure that it doesn’t shift
during the curing process. Follow the same general procedure for back post
sleeves. Allow footings to fully cure before final assembly and use of the goal.

4) See separate “net clip installation diagram” provided with model number EC-824

easy net clips for process and proper location of net clips.