Jaypro Sports ASC-301 - Manual (Page 3)

JAYPRO SPORTS
COMBINATION CENTER STANDARD, ASC-301
LIST OF MATERIALS
PIECE NO. PART NO. DESCRIPTION QTY.
1 AS301 UPRIGHT 1
2 HM225 PULLEY HANGER 1
3 ASC30B BASE ASSEMBLY 1
4 AS302 CABLE BUCKLE ASSEMBLY 1
5 HS1243 3/8”-16 x 3 ¼” HEX HEAD 2
6 HN265 3/8”-16 LOCKNUT 2
7 HN262 5/16”-18 EYE NUT 2
8 HB201 5/16”-18 x 4” EYEBOLT 4
9 HN263 5/16”-18 WING NUT 2
10 AF737 PULLEY SHEAVE 1
11 HN265 ¼”-20 LOCKNUT 1
12 HS278 ¼”-20 x 1 ¼” HEX HEAD 1
13 RP1222 TOP CAP 1
14 HM5054 5/16” SNAP HOOK 2
15 HS323 3/8”-16 x ½” SQUARE HEAD SET 2
16 HS5015 5/16”-18 x 2 ¼” HEX HEAD 2
17 HW2049 5/16” FLAT WASHER 4
18 RW5003 WHEEL 2
19 HN260 5/16”-18 HEX NUT 4
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: ½” BOX WRENCH
9/16” BOX WRENCH (2) OR
ADJUSTABLE WRENCH (2)
IMPORTANT NOTE:
This unit is designed for practice use only. Any attempt to gain competition net height through excessive
cable tension may damage the equipment. Read all instructions carefully before using this unit.
Set your floor plates as per the installation instructions. Allow the grout to cure for a minimum of 12
hours before using the floor plates. The center-to-center spacing for the asc-301 center standard base
is 12”.
1) The complete pulley assembly (see view ‘b’) and cable buckle assembly (4) are to be assembled to the
remaining outside standard so that the side-by-side nets are tensioned from the center upright outward
to each of the outside uprights.
2) See the as-300 combination game standards assembly instructions for complete installation
details. Note that the center upright does not require a guy cable assembly. For best results
when using the center upright, always tension the adjoining nets simultaneously to avoid
excessive loading of the center upright. Never apply complete net tension to one court only.