Jaypro Sports H-1 - Manual (Page 2)

JAYPRO SPORTS
HELMET STACKMASTER, H-1
LIST OF MATERIALS
PIECE NO. PART
NO. DESCRIPTION QTY.
1 H1B3 BOTTOM FRAME 1
2 H1B1 TOP BRACE 1
3 H1U1 UPRIGHT 4
4 EC0025 CAP 56
5 HN264 3/8” HEX NUT 4
6 RW2250 SWIVEL CASTER 4
7 HW337 3/8” WASHER 4
ASSEMBLY INSTRUCTIONS
1. APPLY SWIVEL CASTER (6) INTO WELD NUT ON BOTTOM FRAME (1) AND
TIGHTEN FIRMLY. SECURE THE 3/8” HEX NUTS (5) ONTO THE STEM OF THE
SWIVEL CASTER (6).
2. SLIP PLASTIC END CAPS (4) ONTO THE HELMET RODS AS SHOWN. FOR
EASIER ASSEMBLY, SLIGHTLY MOISTEN THE INSIDE OF EACH END CAP.
3. PLACE THE UPRIGHTS OVER THE TUBING LOCATED ON THE BOTTOM
FRAME. HELMET RODS SHOULD BE AT A 45 ANGLE TO THE CORNERS OF
THE BASE FRAME (1), AND SLIP THE TOP BRACE (2) INTO THE UPRIGHTS.
LEVEL UNIT BY ADJUSTING CASTERS.
IMPORTANT NOTE
THIS UNIT IS DESIGNED FOR THE STORAGE AND TRANSPORTATION OF
FOOTBALL HELMETS ONLY. EXERCISE REASONABLE CAUTION WHEN
TRANSPORTING THIS UNIT OVER THRESHOLDS, DOOR JAMS OR OTHER
SIMILAR OBSTRUCTIONS.