Jaypro Sports PB20-PRO - Manual (Page 2)

Rev-, 05/09
JAYPRO SPORTS
PB20-PRO, 15’ PRO SERIES PLAYER BENCH
PLEASE NOTE:
1) BEFORE EACH USE CHECK EQUIPMENT FOR PROPER CONNECTING
HARDWARE AND STRUCTURAL INTEGRITY. REPLACE DAMAGED OR
MISSING HARDWARE IMMEDIATELY.
2) USE OF THIS EQUIPMENT OTHER THAN INTENDED, MAY BE
HAZARDOUS.
3) ALTERATION OR MODIFICATION OF THIS EQUIPMENT MAY BE
HAZARDOUS AND RESULT IN INJURY. FOR REPAIR OR
REPLACEMENT, CONTACT YOUR DEALER OR JAYPRO SPORTS.
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED:
Electric Drill with Phillips Screwdriver Bit
(1) ½” Socket Wrench and Box Wrench
(1) Rubber mallet
Note: The contoured seat plank (2) requires a different bolt clip (Item 8, measuring 2”
long) than that used for the backrest plank (3), (Item 9, measuring 2-1/2” long).
IMPORTANT NOTICE: TO AVOID RISK OF INJURY ENSURE THAT THE
SAFETY END CAPS ARE INSTALLED ON BOTH THE SEATING PLANK AND
BACK PLANK.
1) ATTACH END CAPS TO BACKREST PLANK. Lay backrest plank
(3) face down on a protective surface. Tap end caps (7) onto each end
of backrest plank (3). Secure each end cap in place using two self-
drilling screws (12).
2) ATTACH END CAPS TO SEAT PLANK. Lay seat plank (2) face
down on a protective surface. Attach both left and right end caps (5,6)
using four self-drilling screws (12).
3) MOUNT SEAT PLANK TO LEGS. For easiest assembly, position
legs on backside, with seat support arm facing up. Space legs at
approximate distance shown. Insert carriage bolt (13) into bolt clip (8)
- attach to each leg in two places using flange nut (16) – see Detail D.
(Note: the bolt clip (8) used to attach the seat plank measures 2” long).
Attach seat plank (2) by positioning slot over bolt clip (8) and rotating
clip into position. Slide seat plank forward (up) so that edge of plank
is flush with edge of leg support arm. Hand tighten seat plank
hardware until braces are installed.