Jaypro sports – Jaypro Sports PB-95SM User Manual
Page 2

REV-
5/9/2011
JAYPRO SPORTS
27’ PLAYER’S BENCH, PB-95SM
LIST OF MATERIALS
PIECE #
PART #
DESCRIPTION
QTY.
1
AR5111
SEAT PLANK 27’
1
2
SML
BENCH LEG
5
3
HN5046
5/16” FLANGE NUT
10
4
EP0018
2” x 2” END CAP
10
5
HB5030
5/16”-18 x 3” CARRIAGE BOLT
10
6
AR5044
HOLD DOWN CLIP
10
7
AR5045A
END CAP
2
8
HS5035
#8 PAN HEAD SCREW x ½”
4
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: PHILLIPS SCREWDRIVER BIT W/ ELECTRIC DRILL (1),
½” SOCKET WRENCH OR ADJUSTABLE WRENCH (1)
1) Slip the end caps (7) snugly onto each end of the plank (1). Using the electric
drill, assemble a self-drilling screw (8) through the cap and into the flange of
the plank. Two screws are required per end cap.
2) For easiest assembly, position seat plank (1) on a level raised surface such
as a desk top, bleacher seat or work bench. Place the carriage bolt (5) and
bolt clips (6) approximately into place within the slots of the plank. Note that
the legs should be no more than 8” from the plank edge or 9” from edge to
center leg.
3) Position the legs as shown and loosely assemble the hardware illustrated in
detail ‘a-a’. Do not fully tighten the hardware at this time. Level the bench
and make sure the legs are adequately spaced apart. Tighten all fasteners
fully.
4) Locate assembled bench into position and carefully mark the hole locations
for each mounting plate. Use fasteners (minimum 3/8” diameter) appropriate
for your surface material. Follow manufacturer’s instructions fully.