Jaypro sports – Jaypro Sports PB-15SM User Manual
Page 2
JAYPRO SPORTS
15’ PLAYER’S BENCH, PB-15SM
LIST OF MATERIALS
PIECE # PART
# DESCRIPTION
QTY.
1
AR5043
SEAT PLANK 15’
1
2
PB751SM
BENCH
LEG
3
3
HN5046
5/16” FLANGE NUT
6
4
EP0018
2” x 2” END PLUG
6
5
HB5030
5/16”-18 x 3” CARRIAGE BOLT
6
6
AR5044
HOLD DOWN CLIP
6
7
AR5045
END CAP
2
8
HS5035
#8 PAN HEAD SCREW x ½”
4
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: PHILLIPS SCREWDRIVER BIT W/ ELECTRIC DRILL (1),
½” SOCKET WRENCH OR ADJUSTABLE WRENCH (1)
1) Slip the end caps (7) snugly onto each end of the plank (1). Using the electric
drill, assemble a self-drilling screw (8) through the cap and into the flange of
the plank. Two screws are required per end cap.
2) For easiest assembly, position seat plank (1) on a level raised surface such
as a desk top, bleacher seat or work bench. Place the carriage bolt (5) and
bolt clips (6) approximately into place within the slots of the plank. Note that
the legs should be no more than 8” from the plank edge.
3) Position the legs as shown and loosely assemble the hardware illustrated in
detail ‘a-a’. Do not fully tighten the hardware at this time. Level the bench
and make sure the legs are adequately spaced apart. Tighten all fasteners
fully.
4) Locate assembled bench into position and carefully mark the hole locations
for each mounting plate. Use fasteners (minimum 3/8” diameter) appropriate
for your surface material. Follow manufacturer’s instructions fully.