Jaypro Sports BLDP-475TRG - Manual (Page 3)

REV-A, 4/10
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED:
(1) 9/16” Socket Wrench and Box Wrench
(1) 3/4” Socket Wrench and Box Wrench
(1) Rubber Mallet
(1) Phillips head screwdriver
•
Unpack all parts and check against parts list to ensure that all have been
included.
•
Inspect all parts for damage. Report any damages to the trucking
company.
Install Feet and Wheel Casters: (Tip n’ Roll Style Only)
1. Attach five (5) rubber feet (bumpers) on the bottom of each leg as shown
in figure 1.
2. Install two (2) wheel casters on the backside of each frame as shown in
figure 2 - fully thread caster stem on, but tighten only finger tight.
Note: The flange of each flange nut should be against the frame member.
FIGURE: 1 FIGURE: 2