Jaypro sports – Jaypro Sports ST75PC User Manual
Page 2

JAYPRO SPORTS
SCORERS TABLE ST75/ST75PC
LIST OF MATERIALS
PIECE NO. PART
NO. DESCRIPTION
QTY.
1
AR5044
BOLT CLIP
12
2
AR5045
END CAP
6
3
HB5030
5/16”-18 x 3” CARRIAGE BOLT
12
4
HN5046
5/16” FLANGE NUT
12
5
HS5035
#8 ZP PAN HEAD SCREW x ½”
12
6
EP0018
2 x 2 END PLUG
8
7
AR5052
7’-6” PLANK
3
8
PBS-L
LEG ASSEMBLY
2
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Phillips Screwdriver Bit With Electric Drill (1),
½” Socket Wrench or Adjustable Wrench (1)
1) Slip the end caps (2) snugly onto each end of each plank (7). Using the electric
drill, assemble a self-drilling screw (5) through the cap and into the flange of the
plank. Two screws are required per end cap. Carefully assemble 2” end caps (6)
into bench legs (8).
2) For easiest assembly, position seat plank (7) on a level raised surface such as a
desk top, bleacher seat or work bench. Place the carriage bolt (3) and bolt clips
(1) approximately into place within the slots of the plank. Note that the outside
legs should be no more than 8” from the plank edge.
3) Position the legs (8) as shown and loosely assemble the hardware illustrated in
detail ‘A-A’. Do not fully tighten the hardware at this time.
4) Stand the unit upright then level the bench and make sure the legs are adequately
spaced apart. Tighten all fasteners fully.