Jaypro Sports BBC-SPRTKT - Manual (Page 4)

Rev-B Page 4 of 8
1) Make up one end of each of the three cables, as shown in Figure 1. Tighten the
cable clamps using a nut driver.
Figure 1: Assemble End Loops
2) Make up the other end of each cable leaving the cable clamps hand tight, as the
overall length may need to be adjusted.
3) Mark the location of the cable anchor as shown in the diagram below. The
spacing and height dimensions shown are for a 12’ wide x 12’ high net. Adjust
dimensions accordingly for different width and height nets.
Figure 2: Anchor Point Locations On Building Wall (Both Ends)
Note: The height of the cables should be set at about 12” below the height of the net. This will
place about 12” of net on the floor to capture the balls.