S ave these instructions, Led code chart, English page 13 – Intex PURESPA 77" JET MASSAGE SPA 2014 User Manual
Page 13

250
PO
S AVE THESE INSTRUCTIONS
(250PO) SPA (JET + HARD WATER) ENGLISH 7.5” X 10.3” PANTONE 295U 01/10/2014
English
Page 13
LED CODE CHART
E90
No water fl ow
• Ensure the unit is plugged and switch on.
• Ensure the outlet cover grid is clean and free
from obstructions.
• Clean or replace the cartridge, see
Maintenance and Storage section.
• Ensure the in/outlet connections on the spa tub
and fi lter pump are not blocked.
• Turn off and unplug the control unit. Plug the
GFCI/RCD and restart all over again.
• If problem persists, contact Intex Service
Center.
E94
Water temperature too low
• If the ambient temperature is below 39°F (4°C),
we recommend not to use the spa.
• Turn off and unplug the control unit. Plug the
GFCI/RCD and restart all over again.
• Press the temperature increase button to set
the desired water temperature.
• If problem persists, contact Intex Service
Center.
E95
Water temperature too high
• Turn off and unplug the control unit. When the
water has cooled down, plug the GFCI/RCD
and restart all over again.
• Press the temperature decrease button to
lower the water temperature.
• If problem persists, contact Intex Service
Center.
E96
System Error
• Turn off and unplug the control unit. Plug the
GFCI/RCD and restart all over again.
• If problem persists, contact Intex Service
Center.
END
After 72 hours of operation,
the pump will hibernate and
the rapid heating and water
fi ltration functions are disabled.
• Press the water fi lter button to re-active the
fi lter pump.
LED Reading CAUSE SOLUTION