Intex 18 FT X 52 IN ULTRA FRAME POOL 2011 - Manual (Page 8)

118
PO
SAVE THESE INSTRUCTIONS
Page 8
(118PO) ULTRA FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 09/14/2010
English
SETUP INSTRU
C
TIONS
POOL SETUP (continued)
• Next slide the vertical legs into the belt loop located in
the middle of the pool liner. The bottom of the leg
should be inside the white restraining rope (6)
(optional) located near the liner’s bottom edge.
Carefully slide the leg into the belt loop and place the
leg’s bottom inside the rope and then insert the top of
the leg into the bottom of the joint. Snap the leg into
joint’s holes by aligning the hole and the spring-loaded
pin. Attach the leg’s end cap (3) to the bottom of the leg
(see drawing 3).
• Grab the frame pool’s top beams in 2 – 3 locations and "shake" the pool to be sure all
the joints, legs and beams "fit into each other".
• Pull gently, in an outward direction, the bottom of the leg making sure the leg is inside
the restraining rope.
• If pool was purchased with a filter pump, read the Krystal Clear™ Filter Pump
Manual first and then proceed to next installation step.
3. Filling of the pool
• Before filling the pool with water, ensure that the drain plug inside the pool is closed and
that the drain cap on the outside is screwed on tightly. Fill the pool with no more than 1
inch
(2.5 cm) of water. Check to see whether the water is level.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely
level. Setting up the pool on unlevel ground will cause the pool to tilt resulting in
the sidewall material bulging
and a potential collapse of the pool . If the pool is not
completely level, you must drain the pool, level the area or move the pool to a
different area that is level, and re-fill the pool,
following the above directions .
• Smooth out the bottom liner wrinkles (from inside the pool) by pushing out where the pool
floor and pool sides meet. Or (from outside pool) reach under the side of the pool,
grasp the pool floor and pull
in an outward direction . If the ground cloth is causing the
wrinkles, have 2 adults pull from opposite sides to remove all wrinkles. Use the properly
assembled pool ladder when entering or exiting the pool during this process.
• Fill the pool with water up to just below the
sleeve line (see drawing 4).
4 . Posting aquatic safety signs
Select a highly visible area near the pool to post
the Danger No Diving or Jumping sign included
later in this manual.
3
3
4
IMPORTANT
Before allowing anyone to use the pool, hold a family meeting. Establish a set of
rules that include, at a minimum, the important safety rules and general aquatic
safety information in this manual. Review these rules on a regular basis and with
all users of the pool including guests.
WATER LEVEL