Intex 10 FT X 30 IN METAL FRAME POOL 2014 - Manual (Page 10)

87PO
SAVE THESE INSTRUCTIONS
English
(87PO) ROUND METAL FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 06/13/2013
Page 10
POOL SETUP (continued)
• Next slide the vertical legs into the belt loop located in the middle of
the pool liner. The bottom of the leg should be inside the white
restraining rope (9) (optional) located near the liner’s bottom edge.
Exceptions are the 10’ (305cm) and 12’ (366cm) size pools. Carefully
slide the leg into the belt loop and place the leg’s bottom inside the
rope and then insert the top of the leg into the bottom of the joint.
Snap this leg into joint’s holes by aligning the holes and the
spring-loaded pin. Attach the leg’s end cap (5) to the bottom of the
leg (see drawings 3.1 & 3.2).
• Upon connecting the last leg, grab hold of the frame pool’s top beams
in 2 – 3 locations. Shake the pool to be sure that all the joints, legs
and beams fit into each other. Ensure that all pins are in position by
pushing them downwards through the holes (see drawing 4.1).
• Pull gently, in an outward direction, the bottom of each leg; making
sure the leg is inside the restraining rope. The leg is to end up in an
upright vertical position.
3. Filling of the pool
• The following applies to pool liners with hose connectors (16’ (488 cm) & below pools). If the pool was
purchased without a filter pump, insert two of the three plugs (11) into the black filter pump outlets. Do
this from the inside of the pool so that water will not run out when filling it. If the pool was purchased
with a filter pump, read the Krystal Clear™ Filter Pump Manual first and then proceed to next installation
step.
• Before filling the pool with water, ensure that the drain plug inside the pool is closed and that the drain
cap on the outside is screwed on tightly. Fill the pool with no more than 1 inch (2.5 cm) of water. Check
to see whether the water is level.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely level. Setting
up the pool on unlevel ground will cause the pool to tilt resulting in the sidewall material bulging
and a potential collapse of the pool. If the pool is not completely level, you must drain the pool,
level the area or move the pool to a different area that is level, and re-fill the pool, following the
above directions.
• Smooth out the bottom liner wrinkles (from inside the pool) by pushing out where the pool floor and pool
sides meet. Or, (from outside pool) reach under the side of the pool, grasp the pool floor and pull in
an outward direction. If the ground cloth is causing the wrinkles, have 2 people pull from opposite sides to
remove all wrinkles. Use the properly assembled pool ladder when entering or exiting the pool during this
process.
IMPORTANT: For certain pool models with restraining rope at the bottom – Never pull from the
restraining rope to smooth out the floor wrinkles as this may cause pool liner damage or leakage.
• Fill the pool with water up to just below the sleeve line.
(see drawing 4.2).
4. Posting aquatic safety signs
Select a highly visible area near the pool to post the Danger
No Diving or Jumping sign included later in this manual.
4.2
FILL LINE
3.1
8
9
5
3
3.2
4
4.1