Compaq MV 740 - Manual (Page 6)

4
Installation
Before installing your monitor, place it in a convenient, well-ventilated location near your computer,
ensure that power to your computer and other peripheral devices is turned off, and proceed as follows:
1. Insert the speaker power cable
1 into the back of the right speaker . Insert the plug from the left
speaker into the socket on the back of the right speaker .
2. Insert the other end of the speaker power cable
3cccc into the back of the monitor .
3. Connect the lime green plug from the right speaker
2 to the audio out socket on the back of
your computer.
4. Connect the pink end of the microphone cable to the microphone socket on the back panel of
your monitor 3bbbb, then plug the other end of the cable into the microphone connector on the rear
panel of your computer
6.
5. Connect the monitor signal cable from the back of the monitor to the blue socket on the back of the
computer
4. Tighten the screws on the end of the connector.
IMPORTANT: Ensure that the signal cable aligns with the 15-pin connector. Do not force the cable onto
the connector or you may damage the signal cable.
( Installation instructions continued on next page.)