Philips CD 502 - Manual (Page 8)

OPERATION PROGRAMMING
REPEATING A TRACK (REPEAT)
• Press REPEAT twice before or during play.
- REPEAT starts flashing and the track will now be
repeated again and again.
• Press REPEAT again to stop the REPEAT function.
STOPPING PLAY (STOP/CM or OPEN/CLOSE)
• Press STOP/CM if you merely wish to stop.
• Press OPEN/CLOSE if you wish to stop and take
out the CD.
You can store 20 tracks from each CD in any required
sequence in a programme If you exceed the
maximum of 20 tracks, FULL lights up.
STORING A PROGRAMME
(NEXT, PREVIOUS and PROGRAM)_____________
• Close the CD compartment by pressing OPEN/
CLOSE.
- The display shows the number of tracks and the
playing time of the CD.
• Press NE)Cr or PREVIOUS until the first track
number you wish to programme appears on the
display.
• Now press PROGRAM within 8 seconds.
- PROGR lights up. followed by a P’ (for Pro­
gramme); the number has now been stored in the
player's memory.
• Select the other track numbers required and store
each track by pressing PROGRAM
STORING A PROGRAM USING INTRO SCAN
• Press INTRO SCAN before or during play
-
SCAN lights up.
- If the tray is open, it will now close
- The first 10 seconds of each track are played in
turn.
• Press PROGRAM at each track you wish to include
in the programme.
- The player immediately starts to play the first 10
seconds of the next track.
• Press PLAY/PAUSE to play the program.
CHECKING THE PROGRAMME (PROGRAM)
• Press PROGRAM before, during or after program­
med play.
- Y (for review) lights up and all the track numbers
appear in the programmed sequence on the
display.
PLAYING THE PROGRAMME (PLAY/PAUSE)
• Press PLAY/PAUSE.
- PMYlights up for a second and play begins with
the first number of the programme.
All keys can be used during programmed play
(except SHUFFLE; the programme will then be
erased). Searching for a passage is limited to within
the track being played.