Operating instructions - alarm – Crimestopper Security Products Series IV Super Rage CS-2011RS User Manual
Page 3
OPERATING INSTRUCTIONS - ALARM
Active Arming / Locking:
Press and release button #1 (Lock symbol) on the transmitter. The
System will arm and confirm with one siren chirp, one light flash,
and the LED will begin to flash. Power locks will lock (if equipped).
Starter disable circuit will turn on. After a short delay to allow the
vehicle and electronics to settle, the system is completely armed.
START
CrimeStopper
#3
#1
#2
#4
LOCK/
TRUNK
REMOTE
UNLOCK/
VEHICLE 2
FLASHLIGHT
START
#5
#6
ARM
DISARM
Disarming: / Unlocking
Press and release button #2 (Unlock symbol) on the transmitter.
System will disarm and confirm with two siren chirps, two light
flashes, and the LED will turn off. Power locks will Unlock and
Interior Dome light will turn on (if installed with these optional
features)
Disarming While Tripped (Triggered):
Disarming the System while it is triggering requires TWO presses of the #2 Unlock Button. The first press of
Button #2 Resets the alarm cycle only (system still armed) while a second press will disarm/unlock the system.
Silent Arming/Disarming (On demand):
To Arm or Disarm the system without siren chirps, press and release both Buttons #2 (Unlock) and #4 (Start)
at the same time. System will Arm or Disarm without siren chirps that one time. Flashing lights and LED will
be the only indicators of Arm/Disarm status. If the system was tripped while you were way, 4 chirps will be
heard to notify you that the system was tripped.
Silent Arming/Disarming (Chirp Defeat):
This system can be programmed to silent arm and disarm using the normal lock and unlock buttons. Flashing
lights and LED will be the only indicators of armed or disarm status. Check with your installer or follow
programming option instructions in the installation manual.
Alarm Triggering
An intrusion into the vehicle or hard impact to the body will sound the alarm and flash the lights for 1 minute.
After 1 minute the trigger cycle will automatically stop and alarm will remain armed to continue protecting the
vehicle. If a door is left open after an intrusion then the unit will cycle a maximum of 5 minutes and continue to
protect the other un-tampered or unopened zones.
3