Cary Audio Design 7.125 - Manual (Page 17)

SPECIFICATIONS
15
Operating the Model 7.125 is a simple procedure. It is designed for long term stability in
virtually any home operating environment. However, if the unit is operated outside the
parameters outlined in this Owner's Manual, damage may result. Please read this manual
carefully before putting your new Model 7.125 power amplifier into operation.
The following section describes the Model 7.125 power amplifier’s basic specifications.
The specifications are subject to change without notice or obligation.
................................................................................................................................................
Audio Input
7 RCA, 7 XLR
................................................................................................................................................
Audio Output
7 pairs of heavy-duty, gold-plated binding posts
................................................................................................................................................
Power Output
7 x 125w RMS @ 8 ohms 7 x 190w RMS @ 4 ohms
from 20Hz to 20KHz from 20Hz to 20KHz
................................................................................................................................................
Frequency Response
20Hz - 20KHz +/- 0.1 dB
................................................................................................................................................
THD
Less than 0.05% at rated output
................................................................................................................................................
Signal-to-Noise Ratio
Greater than 100dB below full rated power A-weighted.
................................................................................................................................................
Crosstalk
Greater than -90dB from 20Hz to 20KHz
................................................................................................................................................
Damping Factor
Greater than 400 from 10Hz to 400Hz
................................................................................................................................................
Slew Rate
50V/mSec
................................................................................................................................................
Input Sensitivity
1.0v for rated output
................................................................................................................................................
Input Impedance
Nominal 50K ohms
................................................................................................................................................
Gain
Voltage Gain of 28dB
................................................................................................................................................
Remote Trigger
3-32v DC at 5mA or greater
................................................................................................................................................
Power Requirements
117/234 Volts AC @ 50/60 Hz
................................................................................................................................................
Dimensions
7.0” H x 17.7”W x 16.6”D
................................................................................................................................................
Weight
55lbs.
................................................................................................................................................
Rock Mounting
Optional brackets are available for mounting the amplifier
in a standard 19 inch equipment rack.
................................................................................................................................................