Connections, Recharging the philips battery pack on board, Connecting the headphones (supplied) – Philips AZ 7182/00 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONNECTIONS
m
3
CQ
Recharging the Philips battery pack on board
(supplied or optionally available)
AY 3361 NiCd battery pack for recharging on board
The battery pack (NiCad) will be recharged if the mains adapter is connected.
Approximate charging time: 14 hours
Note: - Use only the Philips battery pack, as other rechargeable batteries cannot be
recharged on board.
- Disconnect the mains adapter or remove the battery pack after recharging it.
Connecting the headphones
(supplied)
Connect the supplied headphones with the
0/LINE OUT jack.
AY 3674
Note: Use this Jack also for connecting your HiFi system
(signal lead) or your car radio (adapter cassette or
signal lead). In both cases, the volume of the CD
player has to be set to position 8.
Use your head when using headphones
Hearing safety: Do not play your headphones at a high volume. Hearing experts
advise that continuous use at high volume can pemnanently damage your hearing.
Traffic safety: Do not use headphones while driving a vehicle. It may create a
hazard and it is illegal in many countries. Even if your headphones are an open-air
type designed to let you hear outside sounds, do not turn up the volume so high
that you cannot hear what is going on around you.