Centro 6500 User Manual

Page 23

2 1

Attach the warming rack (BP) to the back burner brace (BF) as shown.

Make sure to insert the front 3 bars into the 3 holes of the back burn-

er brace (BF). Place the two legs of the warming rack clip onto the edge

of burner box weldment (BA).

Insert the left and right grease tray rail (CM & CN) into the holes of

upper brace (CJ) as shown.

Use hardware #9 (X2) to fix both rails (CM & CN) as shown.

Assemble the upper rear panel (CK) to the burner box and cart

assembly by using hardware #1, #3, and #4 (x4).

Fix the upper rear panel (CK) to both grease tray rails (CM & CN) by

using hardware #9 (x2) as shown.

Insert the gas tank heat shield (CL) into the holes of upper brace

(CJ) as shown.

Fix the heat shield (CL) to the upper rear panel (CK) by using hard-

ware #9 (x2) (from the back and from the bottom (hardware #9 x2)).

Fig. 8

Fig. 9

Fig. 7