Recharging of philips battery pack on board, Connecting headphones (supplied), Connections – Philips AZ 7272/00R User Manual
Page 9: Connecting headphones
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONNECTIONS
Recharging of Philips battery pack on board
(supplied or optional available)
The battery pack (NiCad) will be recharged if the mains adapter is connected.
Approximate charging time: 14 hours
Notes:
- When using rechargeable batteries, we advise the use of the Philips battery pack
only, as conventional separate Nickel-Cadmium batteries cannot be recharged on
board.
- Disconnect tbe mains adapter or remove the battery pack after recharging it.
Connecting headphones
(supplied)
Connect the supplied headphones (16 ohms/
3.5mm jack plug) with the LINE OUT / Ti jack.
Note: Use this jack also for connecting your HiFi system
(signal lead) or your car radio (adapter cassette or
signal lead), in both cases, the volume of the CD
player has to be set to position 6-8.
Use your head when using headphones
Hearing safety:
Do not play your headphones at a high volume. Hearing experts
advise that continuous use at high volume can pemnanently damage hearing.
Traffic safety:
Do not use headphones while driving a vehicle. It may create a
hazard and it is illegal in many countries. Even if your headphones are an open-air
type designed to let you hear outside sounds, do not turn up the volume so high
that you cannot hear what is going on around you.