Philips AZ1509-17 - Manual (Page 18)

TROUBLESHOOTING
m
s
cs
WARNING
Under no circumstances should you try
to repair the set yourself, as this will
invalidate the warranty.
If a fault occurs, first check the points listed
below before taking the set for repair.
If you are unable to remedy a problem by
following these hints, consult your dealer or
service center.
PROBLEM POSSIBLE CAUSE SOLUTION
No sound/no power VOLUME is not adjusted Adjust the VDLUME
Headphones are connected Disconnect headphones
Powercable is not securely connected Connect the cable properly
Batteries are dead Replace batteries
Batteries are incon-ectly inserted Insert the batteries correctly
Changing over from AC power to battery
supply without removing the plug Remove the plug from the AC MAINS
inlet
No reaction to
operation of any keys Electrostatic discharge Disconnect the set from power supply
reconnect it after a few seconds
Poor radio reception Weak radio signal Aim the antenna for optimum reception:
- FM: incline and rotate external
antenna
- AM: rotate the entire set
Interference caused by the vicinity of
electrical equipment like TVs, video
recorders, computers, engines, etc. Keep the radio away from electrical
equipment
no o' ISC or The CD is badly scratched or dirty Replace or clean the CD, see maintenance
E r r o r indication No CD is inserted Insert a CD
The CD is inserted upside down Insert a CD with the label facing up
The laser lens is steamed up Wait until the lens has cleared
The CD skips tracks The CD is damaged or dirty Replace or clean the CD
SHUtTiE or PROGRAM is active
Switch off shuffle or program play
Poor cassette sound
quality Dust and dirt on the heads, capstan
or pressure roller
Clean the heads, capstans and pressure
roller, see MAINTENANCE
Use of unsuitable cassette types
(METAL or CHRDME)
Dniy use NDRMAL cassettes for
recording
Recording does not work Cassette tab(s) may be snapped off Put a piece of celiophane tape over the hole
Remote control does Batteries are incorrectly inserted Insert the batteries correctly
not function properly Batteries are dead Replace batteries
18
Distance to the set is too far Reduce the distance