Philips AZ 6826 - Manual (Page 10)

PLAYING A CD
PLAYING A CD
• Ensure that the HOLD function is switched off, otherwise the CD player but­
tons will not operate.
• Connect headphones to the PHONES socket.
• Press OPEN to open the CD cover.
• Insert the CD, printed side facing up) and close the
cover. The CD player starts and scans the contents list of
the disc,
disc
appears and then the number of tracks and .
the total playing time of the CD. After that, the CD player stops.
If no CD is inserted, no dISC appears.
• Adjust the volume using the VOLUME control and the bass response using the
DBB selector.
• Start playback by pressing PLAY >.
As soon as playback starts, the display shows the corresponding track number
and the elapsed playing time of that track, see also chapter 'ELAPSED/REMAIN-
ING TIME'.
• For brief interruptions, press PAUSE 01; the time indication flashes. To continue
playback, press PLAY>/PAUSEOO again.
• To stop playback, press STOP □. The display will show the total playing time
and the total number of tracks present on the CD.
• The CD player also goes to position STOP:
- when the end of the CD is reached;
- when the CD cover is opened;
- if the batteries run down or if the power supply is interrupted in another way.
• Open the CD cover only if the CD player is in STOP position.
• To switch off the CD player immediately, press STOP a second time.
• In the STOP position, the CD player automatically shuts down 15 seconds after
the last command. Press PLAY > to reactivate the CD player.
When using an external power supply via the 6 V DC socket, the CD player enters
the standby mode 15 seconds after the last command (30 seconds in the EDIT
mode) and the illumination extinguishes. To reactivate, press PLAY on the CD
player (or any button on the wire remote control for longer than 3 seconds).
Remarks
- If the batteries are exhausted, the CD player will not function normally, e.g. it
will not start. Replace the batteries or use the mains adapter.
- If after pressing PLAY >, nc d I SC appears and the CD player shuts down af­
ter a few seconds, this means that the CD player cannot read the CD. Possible
causes are:
- you Inserted the CD upside down;
- the CD is badly scratched or dirty, see 'Maintenance';
- the lens (x) is steamed up, see 'Maintenance';
- the batteries are exhausted.
10