beautypg.com

Accessories, Power supply settiimg, Fitting a mains plug (u.k. only) – Philips CD 740 User Manual

Page 5: Installation

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

INSTALLATION

ACCESSORIES

With this player are supplied’

- a connection cable,

- a remote control,

- batteries for the remote control

POWER SUPPLY SETTIIMG

Check that the type plate on the rear of your

player indicates the correct supply voltage

If your mams supply voltage is different, consult

your dealer or our Service Organisation

Certain versions of this player are
equipped with a voltage selector

at the bottom of the player which

enables you to set the player to

the correct mains voltage yourself.

position 120V- for all mains voltages between

1WV and 127 V:

position 230 for all mams voltages between

220V and 240 1/

CONNECTIONS

DIGITAL OUT

This output supplies a digital signal and can
therefore only be connected to an input which

IS suitable for this signal.

Use here a lead with one cinch plug on either

end

Never

connect this socket to a non-digital

input of an amplifier, such as AUX, CD, TAPE,

PHONO, etc!

2 ANALOG OUT

For the connecting cable to the amplifier.

Insert a red plug into the 'R' socket and the

other plug into the 'L' socket.

Insert the two other plugs into the correspon­
ding sockets of the CD or AUX input of your

amplifier.
You can also use the TUNER or TAPE IN-
connection, but never the PHONO input!

FITTING A MAINS PLUG (U.K. only)

This apparatus is fitted

with an approved

moulded 13 Amp plug

To change a fuse in

this type of plug
proceed as follows

• Remove fuse cover

and fuse.

• F

i x

new fuse which should be a BS1362 5A,

A S.T A. or BSl approved type.

• Refit the fuse cover

If the fitted plug is not suitable for your socket

outlets, it should be cut off and an appropriate
plug fitted in its place.

if the mains plug contains a fuse, this should have

a value of 5A. If a plug without a fuse is used, the
fuse at the distribution board should not be

greater than 5A.

£

.52

"o)

c

111

NOTE

The severed plug must be disposed to avoid a

possible shock hazard should it be inserted

into a 13A socket elsewhere.

HOW TO CONNECT A PLUG

The wires in the mams lead are coloured in accor
dance with the following code:

BLUE - NEUTRAL' ( N ) and BROWN - LIVE ' ( L).

As these colours may not correspond with the colour

markings identifying the terminals in your plug, pro­

ceed as follows:

• The BLUE wire must be connected to the ter­

minal which IS marked with the letter "N' or

coloured BLACK.

• The BROWN wire must be connected to the

terminal which is marked with the letter X" or
coloured RED.

• Do not connect either wires to the earth termi­

nal in the plug which is marked by the letter ”E"
or by the safety earth symbol or coloured green

or green-and-yellow.

Before replacing the plug cover, make certain that

the cordgrip is clamped over the sheath of the

lead - not simply over the two wires.

This manual is related to the following products: