Power supply, Batteries, Mains – Philips AZ 8057 User Manual
Page 5: Environmental information
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
POWER SUPPLY
Batteries
Open the battery compartment and insert six batteries, type
R20, UM-1 or D-cells (preferably alkaline). Remove the batteries
if they are empty or the set will not be used again for a long time.
Remote control:
Open the battery compartment and insert two
batteries, type AAA, R03 or UM4. Remove the batteries if they
are empty or the remote control will not be used again for a long
time.
Mains
1 Check if the mains voltage as shown on the type plate (on the
base of the set) corresponds to your local mains voltage. If it
does not, consult your dealer or service organisation.
If the set is equipped with a VOLTAGE selector®, set this
selector to the local mains voltage.
2 Connect the mains lead to the MAINS outlet and the wall socket.
The mains supply is switched on.
• The battery supply is switched off when the set is connected to
the mains. To change over to battery supply, pull out the plug
from the unit's MAINS socket.
• To disconnect the set from the mains completely, withdraw
the mains plug from the wall socket.
•
For users in the U.K.:
please follow the instructions on page 2.
•
The typeplate is located on the base of the set.
Environmental information
All redundant packaging material has been omitted. We have done our utmost to make the packaging
easy separable into three mono materials: cardboard (box), expandable polystyrene (buffer) and
polyethylene (bags, protective foam sheet).
Your set consists of materials which can he recycled if disassembled hy a
specialized company. Please observe the local regulations regarding the disposal
of packing materials, exhausted batteries and old equipment.