Philips AZ 8057 - Manual (Page 12)

GENERAL INFORMATION
m
3
C3
CA
sr
General maintenance
• Do not expose the set, batteries, CDs or tapes to humidity or
rain, sand or to excessive heat caused by heating equipment or
direct sunlight.
• The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated !
• You can clean the set with a soft, slightly dampened chamois
leather. Do not use any cleaning agents as they may have a
corrosive effect.
Tape deck maintenance
To ensure a good recording and playback quality of the tape
deck, clean the parts ( a )®© after approx. 50 hours of operation.
Use a cotton bud slightly moistened with alcohol or a special
head cleaning fluid.
Press PLAY and clean the rubber pressure rollers©.
Press PAUSE and clean the capstans © and the heads ®.
Note: Cleaning of the heads® can also be done by playing a
cleaning tape through once.
CD player and CD handling
The lens © of the CD player should never be touched!
The lens may cloud over when the set is suddenly moved from
cold to warm surroundings. Playing a CD is then not possible.
Leave the CD player in a warm environment until the moisture
evaporates.
To take the CD out of its box easily, press the centre spindle
while lifting the CD.
Always pick up the CD by the edge and put it back in its box
after use.
To clean the CD, wipe it off in a straight line from the center
towards the edge using a soft, lint-free cloth. A cleaning agent
may damage the disc!
Never write on a CD or attach any sticker to it.
This set complies with the radio interference requirements of the European Community.
12