Philips AJ3712 - Manual (Page 6)

POWER FAILURE MAINTENANCE
-As soon as a power failure occurs, the complete
clock radio will be switched off.
-As soon as the power supply returns, the numbers
on the display start to flash. This indicates that you
must set the correct time on the clock.
-You can insert a 9 Volts pack battery (type 6F22)
in the clock radio. Should there be a power
failure, the clock will continue to function. You
will not see this, however, because the battery
does not illuminate the clock display. As soon as
the power is switched on again, the display will
indicate the correct time. For clarity: Alarm, radio
and display do not work on battery.
• Before inserting the battery, connect the power
plug to the wall outlet.
• Place the battery in the compartment on the
underside of the clock radio (see diagram).
- Replace the battery once a year. It is not possible
to say precisely how long the battery will last.
The service life depends on how often and for
how long the power supply fails. This varies
according to country and region.
- If you do not intend to use the clock radio for a
long time, it is better to remove the plug from
the wall socket. In addition to this, it is advisable
to remove the battery from the clock radio. This
will prevent any danger of leakage and the clock
radio will not be damaged.
-Fingerprints, dust and dirt on the clock radio
should be removed using a clean and damp soft
cloth or chamois leather. When cleaning do not
use any products which contain abrasive agents
or solvents (benzine, thinner, alcohol etc.). These
might affect the housing.
- Rain, dampness and extreme heat may damage
the clock radio. For this reason it should not be
placed in full sun or close to heating elements for
any period of time.
The type-plate is located on the underside of the
clock radio.