Philips MAGNAVOX AJ 3940/17 - Manual (Page 7)

CONTROLS INSTALLATION
TOP, FRONTSIDE and BACK PANEL
(
5
)
@
d)
©
©
®
(JO)
(ft
SLUMBER - to adjust the slumber time
dav /REPEAT ALARM
- to switch off the alarm for a 9 minute
period
- to set the day for weekend sleeper
activation
24 HR RESET - to stop the active alarm for
24 hours
PUSH*OPEN - to open/close the CD door
TRACK SELECT - to select/review TRACK
SELECT number for ALM 1 or 2
DISPLAY - to show the clock/alarm times
and status of the set
PLAY ► - to start CD playback
■ OFF
- to stop CD/Radio/Slumber function
- to cancel the TRACK SELECT setting
- to cancel alarm setting(s)
DBB - for an enhanced dynamic bass boost
ALM 2 - to set/review/switch off ALM 2
BRIGHTNESS - to change the brightness of
the display illumination
ALM 1 - to set/review/switch off ALM 1
(§)!« /►►!
- to adjust clock/alarm times;
- to set the day
- to skip CD tracks/search for a particular
passage
- to set a CD track for ALM 1 or ALM 2 in
TRACK SELECT mode
- to select the buzzer melody for ALM 1 or
ALM 2
@ WEEKEND SLEEPER - to deactivate ALM1
or ALM 2 for the weekend
@ TIME - to set the clock time
(§) BUZZER - to select the buzzer mode for
ALM 1 or 2 - to select the buzzer melody
@ RADIO ON
- to switch on the radio
- to select radio mode for ALM 1 or ALM 2
@) BAND - to select FM/AM waveband
@ 0 - 3 . 5 mm socket for plugging in
headphones/active speakers
@1 VOLUME - to adjust the sound level
©TUNING - to tune to radio stations
@ Battery door - for backup batteries
@ Pigtail antenna - antenna to improve FM
reception
(© Power cord - for AC power supply
O)
s
UJ
POWER CONNECTION
1. Check if the power supply as shown on the type plate (on the
bottom of the set) corresponds to your local power supply. If it
does not, consult your dealer or service center.
-* If your set is equipped with a voltage selector, found on the
bottom right-hand corner of the set, adjust the selector to
correspond with your local power.
2. Connect the power plug to the wall socket.
- The power supply is now switched on and the numbers on
the display will start to flash. You will need to set the
correct time.
3. To switch off the power supply completely, pull the power plug
out of the wall outlet.