Philips MAGNAVOX AJ 3940/17 - Manual (Page 11)

RADIO ALARM
RADIO RECEPTION
7. Press RADIO
on
to switch on the radio mode.
-* The RADIO indicator appears in the display.
Z Adjust the BAND switch to select the waveband.
3. Use the TUNING control to find your station.
To improve radio reception
FM: extend the pigtail wire at the back of the set
completely for optimum reception.
AM: uses a built-in aerial. Direct the aerial by adjusting the
position of the set.
4. Adjust the sound using the VOLUME and DBB controls.
5. Press ■ OFF to switch off the radio.
— The RADIO indicator disappears from the display and the
radio is switched off.
SEHING THE ALARM TIME
General
Two different alarm times ALM1 or ALM 2 can be set in a
variety of modes. This can be useful when for example you need
to be woken up at a different time during the week or at the
weekend.
WoferThe ALM 1 or 2 button should be held down throughout
steps 1-4 below.
SEHINGALARMI or2
7. Press and hold down the ALM 1 or 2 button.
day appears in the display if you have not set the day
(see SETTING THE DAY)
2. Press or to set and adjust both the hours and minutes:
- With or pressed, the display will increase or
decrease the alarm time rapidly and continuously from
minutes to hours.
- Press hM or briefly and repeatedly to adjust the alarm
time minute by minute.
3. Release or when you have reached the correct alarm
time setting.
4. Select your choice of alarm mode by pressing CD ►, BUZZER
or RADIO.
5. Release the ALM 1 or 2 button.
- The display will show the selected alarm icon , O or
© under ▲ ALM 1 or T ALM 2.
6. To review the alarm time, press your selected ALM 1 or 2
button.
11