Crimestopper Security Products CS-2004DC - Manual (Page 19)

OPERATION
LED TRANSCEIVER (LOW BATTERY WARN)
CR2032 3V
Lithium Battery
Twist and Remove
Battery cover with
a Coin or Screwdriver
Larger "+" Positive
side of battery faces up
CS2004TW1
BATTERY
REPLACEMENT The CS-2004TW1 LED has a low battery warning system.
When the battery voltage is low, the LED pager remote will
stop beeping and flash the Orange & Green LEDs when
buttons are pressed. We recommend replacing the battery for
proper operation. Use a small coin to twist open the battery
compartment and replace the CR2032 Lithium battery as
shown in the diagram at right.
CARJACK PROTECTION
PROGRAMMABLE ACTIVE CARJACK
This feature provides Active remote-operated carjack protection and must be enabled before use through alarm
programming option #12. See page 10. When the Ignition is on (vehicle is running), press and hold Button #2
(Unlock) for more than 2 seconds. Parking lights will flash twice and LED will begin flashing to confirm the Carjack
countdown sequence. 30 Seconds later, the unit will begin a Carjack Cycle consisting of 30 seconds of pre-warning
chirps turning into a full system activation with siren/flashing light pulses for up to 5 min. If the Ignition is turned off
during a Carjack trigger the siren and lights stop but Carjack protection is STILL active. The Siren and Lights will
resume if the Carjacker tries to turn the Ignition back ON. To reset Active Carjack, press Button #2 (UNLOCK) on
the remote and the siren will chirp once, or turn the key on and press and hold the override button for at least 5
seconds (or until the flashing LED shuts off).
19