ISP Technologies VECTOR SL - Manual (Page 3)

PRECAUTIONS
NOTE: IT IS VERY IMPORTANT THAT YOU READ THIS SECTION TO PROVIDE
YEARS OF TROUBLE FREE USE. THIS UNIT REQUIRES CAREFUL HANDELING.
All warnings on this equipment and in the operation instructions should be
adhered to and all operating instructions should be followed.
Do not use this equipment near water. Care should be taken so that objects do
not fall onto and liquids are not spilled into the unit through any openings.
The power cord should be unplugged from the outlet when the unit is left
unused for a long period of time.
DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT. THIS EQUIPMENT SHOULD
BE SERVICED BY QUALIFIED SERVICE PERSONNELL ONLY. DO NOT MAKE
ANY INTERNAL ADJUSTMENTS OR ADDITIONS TO THIS EQUIPMENT AT ANY
TIME. DO NOT TAMPER WITH INTERNAL ELECTRONIC COMPONENTS AT ANY
TIME. FAILURE TO FOLLOW THESE INSTRUCTIONS WILL VOID THE
WARRANTY OF THIS EQUIPMENT, AND MAY CAUSE A SHOCK HAZZARD.
POWER REQUIREMENTS
This unit requires connection to a 120-volt AC outlet. Do not cut or disconnect
the ground pin on the power cord. Do not attempt to connect this unit to any
power source other than the specified 120VAC. The VECTOR SL will typically
draw approximately four amps of current when driven hard.
CAUTION:
Most tube amplifiers require a load on the output to avoid
damage to the amplifiers output transformer. Make sure you
connect an external speaker cabinet to the VECTOR SL
external speaker output before applying power to any tube
amplifier to avoid potential damage to the tube amplifier. This
will ensure a proper load is applied to the output of the tube
amplifier. ISP will not assume responsibility for damage to
any externally connected units.