ISP Technologies VECTOR - Manual (Page 6)

4. INPUT JACK
Connect the speaker output of your guitar amplifier to this input jack. The
VECTOR will internally attenuate the speaker output and apply this signal
to the input of the internal D-CAT amplifier to drive the subwoofer.
5. POWER SWITCH
The power switch turns the VECTOR amplifier on and off.
6. POWER INLET
Connect the supplied IEC power cable to this connector.
FUSE REPLACEMENT
1. Use a small screwdriver as shown to slide the fuse
cover out from the power inlet module. The fuse can
be found inside the fuse cover module after it is
pulled out.
NOTE: A SMALL COMPARTMENT IS ALSO PROVIDED
WITHIN THE FUSE COVER MODULE FOR
STORING A SPARE FUSE.
2. After replacing the fuse with another of identical
specifications, push the fuse cover module fully back
into place, ensuring that the fuse has snapped onto
the fuse holder inside the power inlet module.
VECTOR SPECIFICATIONS
Level range
Limiter attenuation
D-CAT amplifier output power
D-CAT amplifier protection
VECTOR power consumption
Fuse Slo Blo
Dimensions
Weight
20db
30db
400watts RMS @ 4 OHMS
Thermal shutdown/short circuit protect
4 amps peak / 2 amps typical
4 amp-120 volt / 2 amp-220 volt
30” x 30.75” x 16.5”
120lbs