beautypg.com

Introduction – ISP Technologies VECTOR User Manual

Page 2

background image

INTRODUCTION


Congratulations on your purchase of the VECTOR CABINET. You are now the owner of the
most innovative guitar speaker cabinet ever produced. The patent pending VECTOR ACTIVE

GUITAR CABINET has bass on tap, designed as the perfect complement with maximum
performance when used with the THETA HEAD. Years of experience in designing the highest
performance Active Sound Reinforcement cabinets has allowed ISP Technologies engineers
to develop the ultimate Active guitar cabinet. The VECTOR was designed to provide the

maximum possible over the top performance with stunning low-end punch and definition.
With two 12-inch passive speakers that are driven direct from an external guitar head and a
built in 400-watt RMS amplified subwoofer the VECTOR is unlike any cabinet produced to

date.

Please read this manual carefully for a through explanation of the THETA Head and its

functions.


PRECAUTIONS

NOTE: IT IS VERY IMPORTANT THAT YOU READ THIS SECTION TO PROVIDE YEARS OF

TROUBLE FREE USE. THIS UNIT REQUIRES CAREFUL HANDELING.

All warnings on this equipment and in the operation instructions should be adhered to and all

operating instructions should be followed.

Do not use this equipment near water. Care should be taken so that objects do not fall onto and

liquids are not spilled into the unit through any openings.

The power cord should be unplugged from the outlet when the unit is left unused for a long

period of time.

DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT. THIS EQUIPMENT SHOULD BE SERVICED BY

QUALIFIED SERVICE PERSONNELL ONLY. DO NOT MAKE ANY INTERNAL ADJUSTMENTS OR
ADDITIONS TO THIS EQUIPMENT AT ANY TIME. DO NOT TAMPER WITH INTERNAL
ELECTRONIC COMPONENTS AT ANY TIME. FAILURE TO FOLLOW THESE INSTRUCTIONS WILL

VOID THE WARRANTY OF THIS EQUIPMENT, AND MAY CAUSE A SHOCK HAZZARD.

POWER REQUIREMENTS

This unit requires connection to a 120-volt AC outlet. Do not cut or disconnect the ground pin

on the power cord. Do not attempt to connect this unit to any power source other than the
specified 120VAC. The VECTOR will typically draw approximately three amps of current when
driving a 4-ohm load.