Chauvet Q-Roll 150 - Manual (Page 9)

Q-Scan 150 & Q-Roll 150 User Manual 9 2005-11-15/13:23
O
PERATING
I
NSTRUCTIONS
Control Panel
On the control panel you can set the DMX address, set the fixture to Master/Slave mode, reset the
fixture and change fixture personality traits.
Control Panel Functions
F UNCTION O PTIONS N OTES
 / Pan invert
 / Tilt invert
 / Fixture reset
 / Stand Alone (Sound-Active)
 / Stand Alone (Auto Run)
 / Master Mode
 /
(-n) to Enable Channel 7
Pan/Tilt Speed)
 / Display invert
 ~ DMX channel addressing
-y: Activates setting
-n: Disables, skips or selects alternative setting
Applying changes to Functions (Quick Instructions)
Unless other wise stated changes in the control panel can be applied in the following manner.
1. Press [Choose] button repeatedly until the display reads the menu function you wish to change as
illustrated in the table above in section
“Control Panel Functions”
2. The display will read the previously stored settings for the desired function, for example, either
with a
“
-y
” or a “
-n
” as in “P1
-y or P1-n
”.
3. Press the [Up] or [Down] button to toggle between either the
“
-y
” or “
-n
” selection for that
particular menu function.
4. Press the [Enter] button to store your selection. The display will read
“PASS” to confirm your
selection
[Enter] Confirms selection
[Choose] Access to main menu
[Up] Toggle menu items in a forward direction
[Down] Toggle menu items in a reverse direction
Control Board
Enter Choose Up Down
   