Interlogix TruVision IP Open Standards Dome Cameras Installation Manual - Manual (Page 4)

EN 4 Installation Manual
 TruVision IP wedge dome:
TVD-M1210W-2-N(-P) (1.3 megapixel)
TVD-M1210W-2W-N(-P) (1.3 megapixel)
TVD-N210W-4-N(-P) (VGA)
TVD-M2210W-4-N(-P) (2 megapixel)
Features
This section describes the camera features.
 Supports TCP/IP, HTTP, DHCP, DNS, DDNS, RTP/RTSP, PPPoE, SMTP,
and NTP protocols
 Programming and setup through a browser interface
 Live viewing over the network
 50/60 Hz selectable flicker control
 Mono, bi-directional audio
 Digital pan/tilt/zoom (PTZ)
 Supports remote upgrades and maintenance
 H.264 video compression with dual capability
 Supports full HD, HD, 4CIF, 2CIF, CIF and QCIF
 SD card for local storage (except wedge dome)
Installation
This chapter provides information on how to install the cameras.
Installation environment
When installing your product, consider these factors:
• Electrical: Install electrical wiring carefully. It should be done by qualified
service personnel. Always use a proper PoE switch or a 12 VDC UL listed
Class 2 or CE certified power supply to power the camera. Do not overload
the power cord or adapter.
• Ventilation: Ensure that the location planned for the installation of the
camera is well ventilated.
• Temperature: Do not operate the camera beyond the specified
temperature, humidity or power source ratings. The operating temperature of
the camera is between -10 to +60°C (14 to 140°F). Humidity is below 90%.