Interlogix TVC-7120-1 User Manual - Manual (Page 16)

14 TruVision TVC-7120-1 Camera User Manual
On the B/W submenu, you can switch it to ON or OFF to enable or disable
BURST.
EXT1/EXT2 mode:
EXIT1/EXT2 mode enables synchronization of day/night and IR light.
Note: EXIT1/EXT2 mode is only available for TVC-7120-1.
Set image noise reduction
In the Setup Menu, go to NR and select the desired mode. Set the noise
reduction strength of the luminance signal (Y).
Set the camera ID
In the Setup Menu, go to Camera ID and press Enter to display the menu. The
camera ID displayed on-screen can have up to 40 characters.
Camera ID input line
Command line
To enter a character, move the cursor to the desired character and press Enter
to select it. It appears in the input line. Repeat the process until all characters are
entered.
To move the character input position in the input line, move the cursor in the
command line to ← or → and press
Enter .
To clear the input line, move the cursor to CLR and press Enter .