IC Realtime 1.3Mp HD Cost-effective Network IR PTZ Dome Camera (ICIPM2008IR) - Manual (Page 13)

I C R E A L T I M E S E C U R I T Y S O L U T I O N S
10
Dip switch settings are used to change the address, protocol, baud rate and parity of the PTZ. This is not
needing to be changed if connecting it just over the network. You can make these changes by connecting direct
to the camera through its Web UI or our standalone CMS client.
 Note: By default, the PTZ dip switch settings are as follows:
 Address: 1 Baud rate: 9600 Parity: None
Address: Use the table below as an example to set different address to the PTZ. The highest address bit
you can set it '255'. The chart below shows examples up to five (5) different addresses and how to set them
on the dip switch.
 Note: Understand that if you have multiple PTZs on the same RS485 bus, they need to be addressed all
differently.
Protocol: The protocol should be self aware to use with Pelco D/P and ICR - SD. You should not need to
set the protocol manually