IC Realtime 2 Megapixel 1080P Weather-proof IR HD-AVS Camera - Manual (Page 10)

5
3 Installation
Important
 Before the installation, please make sure the installation surface can sustain at
least 3X weight of the bracket and the camera.
3.1 General Fixed Camera Installation
This series product supports wall-mount. Please refer to the steps listed below for installation
information.
Step 1
Please dig four installation holes in the installation surface according to the four holes of the
bottom of the bracket. Insert four expansion bolts from the accessories bag into the holes and
then use four self-tapping screws to secure the bracket on the installation surface. See Figure
3-2.
If you want to install in the wood surface, please skip the first step and then use the self-
tapping screws to install the bracket directly.
Figure 3-1
Step 2
Use the inner hex wrench from the accessories bag to loosen the side panel of the bracket and
two hex knobs at the bottom. Adjust the camera to the proper monitor area and then secure
the knobs of the bracket to fasten the camera.
Step 3
Connect the video output port of the device cable to the rear-end encode device such as DVR
or NVS. Then connect the power port of the device cable to the corresponding power
supplying source.
Now you have completed dome camera installation and cable connection.
You can use the rear-end device to view the monitor video.
3.2 Mini IR Waterproof Fixed Camera Installation