HONDA 2007 S2000 - Owner's Manual - Manual (Page 98)

The scan function gives
you a sampling of all channels while
in the channel mode. In the category
mode, only the channels within that
category are scanned. To activate
scan, press the SCAN button. The
system plays each channel in
numerical order for a few seconds,
then selects the next channel. When
you hear a channel you want to
continue listening to, press the
button again.
To store a channel:
You can store up to 12
preset channels using the six preset
buttons. Each button stores one
channel from the XM1 band and one
channel from the XM2 band.
To store a channel:
Pick the preset button you want
for that channel. Press and hold
the button until you hear a beep.
Once a channel is stored, simply
press and release the proper preset
button to tune to it.
The presets may be lost if your
vehicle’s battery goes dead, is
disconnected, or the radio fuse is
removed.
Repeat steps 2 through 3 to store
the first six channels.
Use the TUNE knob, the
CATEGORY bar, or the SCAN
buttons to tune to a desired
channel.
In category mode, only channels
within that category can be selected.
In channel mode, all channels can be
selected.
Press the CD/XM button. Either
XM1 or XM2 will show in the
display.
Press the CD/XM button again.
The available XM band will show.
Store the next six channels using
steps 2 through 3.
1.
2.
3.
4.
5.
CONTINUED
SCAN
Preset
Playing the XM Satellite Radio (Optional on U.S. Models)
Fe
a
tu
re
s
95
Main Menu Table of Contents