HONDA 2007 S2000 - Owner's Manual - Manual (Page 102)

To load or play CDs, the ignition
switch must be in the ACCESSORY
(I) or the ON(II) position. Each time you press and
release the side of the skip bar,
the player skips forward to the
beginning of the next track. Press
and release the
side of the bar
to skip backward to the beginning of
the current track. Press it again to
skip to the beginning of the previous
track. To play the radio when a CD is
playing, press the AM/FM button.
Press the CD button again to switch
back to the CD player.
If you turn the system off while a CD
is playing, either with the PWR/VOL
knob or by turning off the ignition
switch, the disc will stay in the drive.
When you turn the system back on,
the CD will begin playing where it
left off.
You operate the CD player with the
same controls used for the radio. To
select the CD player, press the CD
button. The number of the track
playing is shown in the display. The
system will continuously play a CD
until you change modes.
Insert a CD about halfway into the
CD slot. The drive will pull the CD in
the rest of the way and begin to play
it. When the system reaches the end
of the disc, it will return to the
beginning and play the disc again.
To move rapidly within a track, press
and hold
or .
To move rapidly within a
track, press and hold the SEEK/
SKIP bar. Press and hold
to
move forward. Press and hold
to move backward. Release the
bar when the system reaches the
point you want.
CONTINUED
To Play a CD
SKIP
To Change or Select Tracks
SEEK
Playing a CD
Fe
a
tu
re
s
99
Do not use discs with adhesive labels.
The label can curl up and cause the
disc to jam in the unit.
Main Menu Table of Contents