HONDA 1984 Civic Coupe - Owner's Manual - Manual (Page 416)

415
uu Fuses u Inspecting and Changing Fuses
Han
d
lin
g the U
n
expected
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK ( 0 *1 . Turn
headlights and all accessories off.
2. Remove the fuse box cover.
3. Check the large fuse in the engine
compartment.
u If the fuse is blown, use a Phillips-head
screwdriver to remove the screw and
replace it with a new one.
4. Inspect the small fuses in the engine
compartment and the vehicle interior.
u If there is a burned out fuse, remove it
with the fuse puller and replace it with a
new one.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
1 Inspecting and Changing Fuses
NOTICE
Replacing a fuse with one that has a higher rating
greatly increases the chances of damaging the
electrical system.
Replace fuse with a spare fuse of the same specified
amperage.
Confirm the specified amperage using the charts on
P. 413 to 414.
There is a fuse puller on the back of the engine
compartment fuse box cover.
Combined
Fuse
Blown Fuse
Fuse Puller
14 CIVIC 2D_SI-31TS86210.book 415 ページ ２０１４年１月２９日 水曜日 午後８時９分