beautypg.com

HONDA 2015 Civic (HF) - Owner's Guide (Revised 12/12/2014) User Manual

Page 13

background image

18 |

| 19

SAFETY

SAFETY

TABLE OF CONTENTS

INDEX

VISUAL INDEX

VOICE COMMAND

INDEX

SAFETY INFORMA

TION

CUSTOMER

INFORMA

TION

INSTRUMENT P

ANEL

SPECIFICA

TIONS

VEHICLE

CONTROLS

MAINTENANCE

AUDIO AND

CONNECTIVITY

HANDLING THE

UNEXPECTED

BLUETOOTH®

HANDSFREELINK®

DRIVING

NA
VIGA

TION

Installing a Child Seat with a Lap/Shoulder Seat Belt

1. Place the child seat on the vehicle seat.

2. Route the seat belt through the child seat 

according to the seat maker’s instructions, and

insert the latch plate into the buckle. Insert the 

latch plate fully until it clicks.

3. Slowly pull the shoulder part of the belt all the 

way out until it stops. This activates the lockable 

retractor.

4. Let the seat belt completely wind up into the 

retractor, then try to pull it out to make sure the

retractor is locked. If you are able to pull the 

shoulder belt out, the lockable retractor is not 

activated. Pull the seat belt all the way out, and 

repeat steps 3 – 4.

5. Grab the shoulder part of the seat belt near the 

buckle, and pull up to remove any slack from 

the lap part of the belt. When doing this, place 

your weight on the child seat and push it into the

vehicle seat.

6.  Make sure the child seat is firmly secured by 

rocking it forward and back and side to side; little 

movement should be felt.

7.  Make sure any unused seat belt that a child 

can reach is buckled, the lockable retractor 

is activated, and the belt is fully retracted and 

locked.

  To deactivate a lockable retractor, release the buckle and allow the seat belt to 

wind up all the way.

Adding Security with a Tether

A tether anchorage point is provided behind each rear seating position. 

Regardless of whether it is installed with LATCH or a seat belt, a child seat that 

comes with a tether should use the tether for additional security.

1. Locate the appropriate tether anchorage point

and lift the cover.

2. raise the head restraint to its highest position,

then route the tether strap through the head

restraint legs. Make sure the strap is not twisted.

3. Secure the tether strap hook onto the anchor.

4. Tighten the tether strap according to the seat

maker’s instructions.

Tether anchorage points

Anchor

Outer position

Center position

Anchor

Anchor

Cover

Tether

strap hook

Tether

strap hook