HONDA 2015 Accord Sedan - Owner's Manual - Manual (Page 519)

518
uu Replacing Light Bulbs u Brake/Taillight and Rear Turn Signal Light/Rear Side Marker Light Bulbs
Main
tenan
ce
Brake/Taillight and Rear Turn Signal Light/Rear Side
Marker Light Bulbs
When replacing, use the following bulbs.
1. Remove the holding clips using a flat-tip
screwdriver, then pull the lining back.
2. Turn the socket to the left and remove it.
3. Remove the old bulb and insert a new bulb.
Brake/Taillight: LED
Rear Turn Signal Light: 21 W (Amber)
Rear Side Marker Light: LED
Brake/Taillight/Rear Side Marker Light: 21/5 W
Rear Turn Signal Light: 21 W (Amber)
1 Brake/Taillight and Rear Turn Signal Light/Rear Side Marker Light
Bulbs
Brake/taillight and rear side marker light bulbs are
LED type. Have an authorized Honda dealer inspect
and replace the light assembly.
When removing the clip, insert a flat-tip screwdriver,
then lift and remove the clip.
Insert the clip with the pin raised, and push until it is flat.
Models with LED type brake/taillight
Clip
Push until the
pin is flat.
Models with LED type brake/taillight
Models with bulb type brake/taillight
Holding Clip
Bulb Socket
Bulb *
Socket *
* Not available on all models
15 ACCORD 4D-31T2A6200.book 518 ページ ２０１４年７月２２日 火曜日 午後１０時３２分