beautypg.com

Training a button – HONDA 2015 Accord Sedan - Owner's Manual User Manual

Page 338

background image

337

uu

HomeLink® Universal Transceiver

*

u

Training HomeLink

Features

Training a Button

1

Training HomeLink

Retraining a Button
If you want to retrain a programmed button for a
new device, you do not have to erase all button
memory. You can replace the existing memory code
using this procedure:

1. Press and hold the desired HomeLink button

until the HomeLink indicator begins to blink.

2. Continue to hold the HomeLink button and

follow steps 1 - 3 under “Training a Button.”

Indicator remains on
for about 25 secs.

Standard transmitter

Indicator blinks rapidly for
2 secs, then remains on for
about 23 secs.

Rolling code transmitter

Erasing Codes
To erase all the codes, press and hold the two outside
buttons until the HomeLink indicator begins to blink
(about 10 to 20 secs). You should erase all codes
before selling the vehicle.

If you have any problems, see the device’s
instructions, visit www.homelink.com, or call
HomeLink at (800) 355-3515.

4.

a.

3.

2.

5.

a.

b.

1. Position the remote transmitter you wish to link 1 to 3 inches (3 - 8 cm) from the

HomeLink button you want to program.

Press and hold the desired HomeLink button and the button on
the remote transmitter. Does the HomeLink indicator (LED)
blink after 10 secs?

Press and hold the
programmed HomeLink
button for about a sec.
Does the device (garage
door opener) work?

Press and hold the remote and the HomeLink
button at the same time. Then, while
continuing to hold the HomeLink button,
press and release the button on the remote
every 2 secs.
Does the LED blink within 20 secs?

Training
Complete

Press and hold the HomeLink button again.

Press and hold the HomeLink
button again.
The remote-controlled device
should operate.

Training Complete

The remote has a rolling code. Press the
“learn” button on the remote-controlled
device (e.g. garage door opener).

Within 30 secs, press and hold the
programmed HomeLink button for 2 secs.

HomeLink indicator blinks for 2 secs,

then remains on.

HomeLink LED

is on.

YES

NO

YES

YES

NO

NO

15 ACCORD 4D-31T2A6200.book 337 ページ 2014年7月22日 火曜日 午後10時32分