Haltech Platinum Interceptor - Manual (Page 14)

Interceptor Manual
14
The front-end software uses Com Port1 as the default communications port. Should there be a
need to select another com port, for example if the computer has no RS232 port and a virtual
USB RS232 port is being used, then the user can select the desired Com Port in the
Comms->Comms Setup menu. This needs to be done when the Haltech Interceptor is offline.
If the user needs to reset the Haltech Interceptor, for example after a setup change, the user can
select Comms->Reset ECU. The user will be prompted about the progress of the reset of the
interceptor in the status bar. Once complete the status bar will display "Interceptor Connected"
and the changes will be applied. Should the user need any further guidance then the user should
press F1 or select help from the menu.