Guardian Technologies SD1000 - Manual (Page 3)

oPEraTioN
always make sure the power switch on the bottom of the unit is in the oFF 1.
position before installing or replacing batteries.
Remove the cover of the battery compartment located on the bottom
2.
of the unit.
Install 4 AAA batteries, observing proper +/- polarities as indicated inside
3.
of the compartment.
Replace the cover of the battery compartment.
4.
iMPorTaNT
To avoid accidental dispensing of liquid, it is suggested to install batteries
BEFORE filling the dispensing tank.
TiPS
Replace old batteries with new ones when the ‘automatic dispensing’ of the 1.
product becomes noticeably weaker.
*Battery life will depend on frequency of use and thickness of liquid being dispensed.
If there is liquid in the unit when batteries need to be replaced, always 2. make
sure to hold down the tank cover to prevent liquid from flowing out, or remove
liquid completely and reinstall when filling is complete.
Remove the batteries if the unit is not going to be used for an extended
3. period
of time (ie - vacation).
iNSTaLLiNG or rEPLaciNG BaTTEriES
aDDiNG LiQuiD To ThE DiSPENSiNG TaNK
Make sure the power switch on the bottom of the unit is in the OFF position. 1.
Access the dispensing tank by pressing your thumb against the indent and 2.
lifting off the tank cover.
Fill the dispensing tank with liquid to MAX fill line.
3.
iMPorTaNT: Do NoT ovErFiLL DiSPENSiNG TaNK WiTh LiQuiD.
Replace the tank cover.
4.
iMPorTaNT
The dispensing tank must be over 1/8 of the way filled with liquid for the •
unit to properly dispense.
Never fill the dispensing tank above the MAX level marked on the outside
• of
the dispensing tank, otherwise unit will not dispense liquid properly.
uSE oNLy ThE FoLLoWiNG LiQuiDS iN ThE DiSPENSiNG TaNK:
Hand Soap •
Dishwashing Soap •
Hand/Body Lotion •
Hand Sanitizer •
Due to varying thicknesses of liquids, the rate
and quantity of dispensing will also be varied.
E-3 E-4 E-5
oPEraTioN (coNTD)
To turn ‘automatic dispensing’ function ON, slide the power switch on the 1.
bottom of the unit to the ON position.
Place hand under the dispensing nozzle, the built-in infrared sensor will
2.
detect your hand and the unit will automatically dispense liquid from the
nozzle.
Slide the power switch to the OFF position to deactivate the ‘automatic
3.
dispensing’ function.
NoTE
LED illuminating indicator (inside dispensing tank) will light up when liquid is being
dispensed.
TiP
During the first use of the Touchless Liquid Dispenser, please repeatedly activate the
‘automatic dispensing’ function several times until the dispensing becomes normal.
*This may also be necessary if the unit is idle for a long period of time.
oPEraTiNG ThE LiQuiD DiSPENSEr
ProBLEM SoLuTioN
Dispenser is not working. Replace batteries.
Turn power switch to ON position.
Liquid is not dispensing properly
or weak dispensing.
Replace batteries; make sure liquid added is not too
thick - should NOT be thicker than hand lotion.
Repeatedly activate the ‘automatic dispensing’
function several times (See TIP page E-5).
Liquid dispensing too quickly. Liquid may be too thin (see IMPORTANT page E-4 for
types of liquids to use in dispenser).
TrouBLEShooTiNG GuiDE