Parts and specifications, Specifications, Parts – Guardian Technologies SD1000 User Manual
Page 2

!
iMPorTaNT SaFETy iNSTrucTioNS
SavE ThESE iNSTrucTioNS
rEaD aLL iNSTrucTioNS BEForE uSiNG ThiS aPPLiaNcE.
TouchLESS LiQuiD DiSPENSEr iS iNTENDED For houSEhoLD
uSE oNLy.
WarNiNG: When using electrical appliances, basic safety precautions
should always be followed.
Do not immerse the unit (even the bottom) in water to avoid the malfunction
•
of the inner electrical parts of the unit.
Do not try to wash the unit otherwise the washing liquid will penetrate
•
inside of the unit and rust the inner electrical parts.
Always place the unit with liquid upright on a level countertop.
•
For normal “automatic dispensing,” do not mix water with liquid soap,
•
santizer or lotion.
Do not expose the unit directly to strong sunlight otherwise it will cause the
•
malfunction of the infrared sensor.
Do not allow to be used as a toy. Close attention is necessary when used by
•
or near children.
Use only as described in this manual.
•
If appliance is not working as it should, has been dropped, damaged, left
•
outdoors or dropped in water, call Customer Service at 1.866.603.5900.
Remove batteries before any routine cleaning or maintenance.
•
Leaks from battery cells can occur under extreme conditions. If the liquid gets
•
on the skin (1) wash quickly with soap and water or (2) neutralize with a mild
acid such as lemon juice or vinegar. If the liquid gets into the eyes, flush
them immediately with clean water for a minimum of 10 minutes. Seek
medical attention.
Use only 4 AAA batteries (4).
•
E-2
E-3
ParTS aND SPEciFicaTioNS
Soap Tank
cover
Dispensing
Tank
Dispensing
Nozzle
Model No.
Batteries
Power consumption
SD1000
(4) Four
AAA Batteries*
3W
SPEciFicaTioNS
BoTToM viEW oF
TouchLESS SoaP + LiQuiD DiSPENSEr
oN/oFF
Power Switch
Battery
compartment
Battery
compartment
Latch
SiDE viEW oF
TouchLESS SoaP + LiQuiD DiSPENSEr
infrared
hand Sensor
ParTS
LED illuminating
indicator
Located inside
dispensing tank.
*Batteries NOT included.