Guardian Technologies H3000 - Manual (Page 4)

E-6 E-7
6. Power Button
Before turning on make sure there is water in the unit.
Press the Power Button. The unit will display the current
humidity in the room. Once the unit is turned on it may take
a short time for the humidity reading to stabilize.
7. The current humidity level in the room will be shown on the
display. The humidity reading will not display below 25%.
8. Timer Button
Press the Timer Button and set the number of hours you
would like your Ultrasonic Humidifier to run
(1-hour, 2-hours, up to 12 hours).
- If you press the button during operation the remaining time is displayed.
- Press it again to adjust the time.
(Co- means Constant Humidification)
9. Spray Control Button
When you press the Spray Control Button there are
four options to choose from:
Press once for WEAK
Press twice for MIDDLE
Press three times for STRONG
Press four times for TURBO
*You will notice the lights get higher as the spray increases.
10. Auto
Press once for auto. This will keep the unit running continuously with
warm humidification. When selected this setting will automatically
work to maintain the humidity in the room at a comfortable level. During
this mode the unit operates at a warm temperature and may shut off
when it reaches optimal humidity. It will restart again as the humidity
level begins to decrease.
11. Sleep
Press twice to activate sleep mode. In this mode the unit will run at
warm humidification for 3 hours then shut off. When selected this
will also turn on the moon (sleep indicator) and turn off all other
display lights.
12. Cool/Warm Button
Press to select cool or warm humidification. Water
temperature is maintained at 40 degrees for cool and 80
degrees for warm. Warm vs. cool mist is a matter of
personal preference; warm will humidify room quicker.
13. Humidity Control Button
Press the Humidity Control Button to change the humidity level.
Humidity level options:
30%, 35%, 40%, 45%, 50%, 55%, 60%, 65%, 70%, 75%, 80%.
Five seconds after pressing this button the current humidity
level will be displayed.
This will not affect the spray output.
Co - means Constant Humidification
14. Water Refill Button
When the Water Refill Button lights up it is time to refill
the water tank.
15. Night Lamp Button
Press the Night Lamp Button at the top of the unit to
illuminate the night light feature.
16. Current Temperature Button
Press to display the current temperature in your room.
17. Turn spout to select preferred direction of humidity spray.