beautypg.com

Troubleshooting guide, Additional functions, Spa260 – Guardian Technologies SPA260 User Manual

Page 5: After each use, Problem solution

background image

E-8

E-9

PRObLEM

SOLUTION

Water vapor not produced.

Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try again.

Air blows but water vapor is

not produced.

Excessive Water: Remove a certain amount of water from

the tank.

The diffuser mist has a bad smell.

Poor maintenance or dirty water: Clean the product thoroughly, and

fill it with fresh water.

Unit has stopped working.

No or low water. Unplug unit and refill tank.

Water is accumulating outside of unit

or area surrounding unit.

Unit not level and water is accumulating. Unplug and place on

level surface. Raise unit on a water-resistant level surface 2-3 feet

off of floor.

Increased noise level.

Unit must be placed on a flat, level, hard surface. Make sure it is

NOT placed on a soft or absorbent surface.

TROUbLESHOOTING GUIDE

Additional aromatherapy essential oils

can be purchased at www.guardiantechnologies.com

SPA260

1.

Power: Touch the Power Button to turn the diffuser on and off.

2.

Clock Display: Press the “Timer” Button for 4 seconds to enter the setting mode for

the clock (the LED display will flicker). Touch the “Light” Button to set the Minutes.

Touch the “Alarm” Button to set the Hours.

Note: Repeately press to scroll through the Minutes/Hours when setting the time. Unit will set

once complete.
3.

Alarm Clock: Press and hold the “Alarm” Button for 3 seconds to enter the setting

mode (the LED display will flicker). Touch the “Light” Button to set the Minutes. Touch the

“Alarm” Buttton to set the Hours.

Note: Repeatedly press to scroll through the Minutes/Hours when setting the alarm. Unit will

set once complete. When the time you set for the alarm arrives, the device will sound for

60 seconds. The device and light will also turn on unless there is no water.

4.

Light: Touch the “Light” Button to select lighting mode. Touch repeatedly to select color.

Color

order is: auto color changing, red, green, or blue. Final touch will turn off the light.

5.

Timer: Touch the “Timer” Button to select when you want the diffuser to shut off. Touch

repeatedly to select the time of: 30, 60, 120 or 180 minutes. Final touch will turn off the timer.

AFTER EACH USE

1. Turn the device OFF and unplug the unit from the electrical outlet. Lift off the top cover.
2. Drain and rinse the water tank thoroughly to remove any sediment and dirt. Wipe clean and dry

with a clean soft cloth or paper towel.
3. Remove water and clean the water tank after each use.

IMPORTANT: Do NOT fill with HOT water as this may cause leaking. Remove the water from the

tank when the diffuser is not in use.

NOTE: IF YOU EXPERIENCE A PRObLEM DO NOT ATTEMPT TO OPEN THE MOTOR

HOUSING YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE

TO THE DIFFUSER OR PERSONAL INJURY.

ADDITIONAL FUNCTIONS

ON/OFF

ALARM

LIGHT

TIMER

ON/OFF

ALARM

LIGHT

TIMER

ON/OFF

ALARM

LIGHT

TIMER

ON/OFF

ALARM

LIGHT

TIMER

ON/OFF

ALARM

LIGHT

TIMER

ON/OFF

ALARM

LIGHT

TIMER

ON/OFF

ALARM

LIGHT

TIMER

ON/OFF

ALARM

LIGHT

TIMER

ON/OFF

ALARM

LIGHT

TIMER

This manual is related to the following products: