Great Planes U-Can-Do 3D 46 ARF - GPMA1269 - Manual (Page 9)

❏ ❏
2. Using needle nose pliers, pull the string end out of
the right wing's servo hole. Tie the string to the end of the
servo lead. Note: Take care not to pull the string loose from
the other side of the wing.
❏ ❏
3. Pull the center of the string out of the servo hole in
the wing. It might take a little fishing to get it out. Take your
time. Use the string to pull the servo wire through the wing,
being careful to not pull the string loose from the other end
taped in the wing. Fit the servo in the wing. Enlarge the
opening if necessary.
❏ ❏
4. Drill 1/16" [1.6mm] holes through the servo mount
for the servo screws. Add a few drops of thin CA to the holes
and allow to fully harden. Mount the aileron servo using the
hardware that came with the servo.
❏ ❏
5. Make a mark on the bottom L.E. of the right aileron
7-3/4" [197mm] from the inboard end of the aileron.
❏ ❏
6. Center a control horn on the mark you made. Drill
two 1/16" [1.6mm] holes through the aileron for mounting the
control horn. Mount the control horn using the 2-56 x 1/2"
[19mm] socket head cap screws (SHCS) with the nylon
backing plate on the top-side of the aileron. Note: Turning a
2-56 tap through the back plate holes makes it easier to get
the SHCS to thread into them.
❏ ❏
7. Thread a clevis 25 turns onto the end of one 12"
[305mm] pushrod. Slip a silicone retainer over the pushrod
down to the clevis.
Correct Incorrect
9