Great Planes Spirit of St. Louis ARF - GPMA1152 User Manual

Page 13

❏

4. Using 6-minute epoxy, glue the tail struts onto the

stabilizer and fuselage in the position shown.

❏

1. Remove the wing by unscrewing the strut screws and

the main wing screw to gain access to the radio
compartment.

❏

2. Remove the control arms from your servos. Use the

hardware and screws included with your servos to install the
servos upside-down in the servo bay.

❏

3. Using double-sided tape or hook-and-loop material, install

your receiver and speed control. Install them on opposite sides
of the fuselage to reduce the possibility of interference.

❏

4. Install the included pushrod connectors onto the servo

arms. You may have to enlarge the holes in your servo arms
to do so. Center the servos with your radio and install the
servo arms onto the servos.

❏

5. Slip the 1/32" [.8mm] wire pushrods into the pushrod

guide tubes. As they emerge into the radio bay, insert them
through the pushrod connectors.

❏

6. Connect the pushrods to the innermost holes on the

control horns. Secure them with the included Micro
FasLinks. Center the control surfaces and tighten down the
easy-adjusters on the servos.

❏

7. Reinstall the wing.

Radio Installation